Fusion 360 Advanced CAM Training Class

  • August 17, 2017 - August 18, 2017
    9:00 am - 5:00 pm

This two day class is focused on Fusion 360 Advanced CAM including:

  • Modeling Fixturing & Workholding systems
  • Multiple setups & coordinate systems
  • 3D toolpaths
  • Advanced toolpath containment
  • Rest Machining
  • 3+2 Machining

Class Prerequisites:  You must be familiar and comfortable with Fusion 360 (or HSMWorks) CAM.

Class runs from 9AM until 5PM with a break for lunch from 12-1PM

Refund Policy:
Cancellation 31 Days or More in advance of class:  100% Refund
Cancellation within 30 days: 50% Refund
Cancellation within 10 days or No Show:  No refund, but we will offer 50% discount on one future class of equal or lesser value

Students are responsible for travel and accommodations to Zanesville, OH.  Closest airport CMH (Columbus) is about an hour away.

Additional information at http://www.nyccnc.com/training



1554 Fairview Road, Zanesville, Ohio, 43701, United States



  1. Hi all,

    I’d like to take the advanced cam class, however the prerequisites state must be comfortable with Fusion360. I know a few CAD systems, but not Fusion. Would the curriculum from the 1st two classes be enough? Anyway I can decide after I finish the 2nd course? Last question is will there be lessons / notes from the different classes?

    • Joseph – you need to be comfortable with the layout, terminology, etc of Fusion, as the advanced class dives into deeper topics. Yes, the first class is sufficient!

Leave a Reply

Your email address will not be published. Required fields are marked *